A swimming pool choking with algae, particles, dirt, or most likely a decomposing rat is every owner’s ground pool nightmare. Using a pool cleaning service might cost you significantly more, making the situation seem even more hopeless.
There comes a time when the very best choice is to drain the pool. It might be the last alternative on your mind, which is, however, required. Because of the price and tool requirements, you may be anxious about how to do it. If you want to do this, either an electric pool pump or a garden hose siphon will work.
Water from an outdoor faucet helps create the siphon. Right here, we explain the simple steps of just how to drain pipes in a pool utilizing a garden hose pipe. Read more below on How to drain a pool with a garden hose.
- 1 How to drain a pool with a garden hose
- 1.1 Pick you wish to drain pool partially or totally
- 1.2 Check the pool’s water level.
- 1.3 Choose the correct hoses size.
- 1.4 Select the pool water disposal method
- 1.5 Draining Your Pool
- 1.6 Cut a few feet off the hose
- 1.7 Connect the end of the hose to a faucet
- 1.8 Other ends of the hose to pointe up
- 1.9 Start drain the water
- 1.10 Finish
- 1.11 Remove Any Water Remaining After Draining.
- 1.12 Dry the pool
- 2 FAQs
- 3 Conclusion
How to drain a pool with a garden hose
If your pool pump broke – or if it never had a pump in the first place – you can still drain the pool without emptying the water one bucket at a time. You can quickly do it on your own without additional assistance by the use a yard hose.
Pick you wish to drain pool partially or totally
Drain your pool with a garden hose is a straightforward procedure that can last one hr, depending on the pool’s dimension. If you have to wait for the entire pool to drain pipes, it can likewise take numerous hrs.
A pool pump and a garden hose are often used to drain quickly if you should like to drain your pool quickly. By siphoning, can delete the water. This method is suitable if you want to replace the swimming pool’s liner with a new one.
Can use it for partial drainage pool water since it doesn’t need much pressure. Making this decision is also crucial because you can then choose whether you must obtain a pool automated cleaner or not.
Check the pool’s water level.
May change the pool water level, depending upon the weather condition, how many individuals, and the times we use the pool remain.
Rainwater may cause the water levels to rise, and this requires that excess water be reduced to maintain the desired level. A garden hose comes in handy with continuous rainfall, and it can solve your problem.
Choose the correct hoses size.
We will need a hosepipe long enough to connect from the pool to the drain. So long garden hose is necessary to have one end wholly submerged in the pool while the other is attached to an outdoor faucet.
Be careful – a thin pipe will take a long time to siphon the water.
Select the pool water disposal method
Excess or used water needs proper drainage to prevent flowing in your yard. Reckless water drainage might harm the community, tornado drains, and roads. It may cause health hazards to the neighbors as the water can be contaminated with dirt and dust. You may organize to drain it right into your house drainage.
Do not flush the pool water into the storm sewer, street, or outdoor drains. Storm sewers tend to drain out to nearby natural sources such as lakes or river banks. Many neighborhoods have specific regulations regarding pool and bathtub water usage.
Check a local municipal website or call the municipal water to be sure you’re draining a pool that is permitted under state law. The chlorine and chemicals in the pool water can damage the ecosystem. These are not just harmful to human health but also to the environment.
Draining Your Pool
After determining where to dump the excess water, there are numerous techniques for siphoning the water.
Starting a siphon with a garden hose is often the most complex part for many people, and why do people use a submersible pump or utility pump for the drained pool instead. Fortunately, once you’ve got the hang of this draining, you should be able to do it pretty easily every time you drain your pool.
Cut a few feet off the hose
To siphon your ground pool, you can either cut a few feet off either end of a garden hose or use your entire hose.
Connect the end of the hose to a faucet
Make sure you connect the end of the hose to a nearby faucet. Ensure that all air has been removed by holding the other end above the rest and waiting until pool water comes out of it.
Other ends of the hose to pointe up
Keep the other end of the hose pointed up, so there is no water coming out of the hose as you unhook it from the faucet (basically, hold each end of the hose with each hand until all the water is in it).
Start drain the water
Using the hose to drain the water, submerge one end inside the ground pool, near the center. Lift the end of the hose out of the water and pull it to the drainage area. Place the hose on the ground or close to the drain or clean out. Remove the cap from the end of the hose to start the siphon. When you are siphoning water into a drain or sewer cleanout, maintain an air gap between the end of the hose and the drain or cleanout to prevent backflow contamination.
Following that, you start the draining process of your pool. When you are done, raise the end of the hose, which was inside the water, to the surface of the water. Frequently check the end of the hose to make sure that it does not drop. But keep in mind – as with an electric pump, garden hose siphons won’t drain pool water completely
Warning! Do not leave the pool unattended while draining water.
The process is currently complete, and you can draw the whole hose pipeline out of the pool. You can use just one garden hose, but use more if you want to drain water faster.
Remove Any Water Remaining After Draining.
Remove the remaining water – this step is only for complete drainage when you need to replace your liner. It may not be necessary to drain all the water in some circumstances. There are many ways to do this, but the fastest is to suction it out with a pump or a wet/dry vac.
If you want to spare the expense, you can use buckets or other containers to remove as much water as you can.
Dry the pool
The final step in replacing the liner or maintaining a dry pool needs to be drying the pool. Algae cannot grow when it is dried. And it is beneficial if you don’t want to fill the pool again. For example, if you close the pool for winter. Just let it dry in the sun. No additional effort is required.
How long does it take to drain the pool with a garden hose?
Draining your pool with a garden hose is a simple process that can last one hour, depending on the pool’s size. It can also take many hours if you have to wait for the entire pool to drain.
But you are probably looking at somewhere between 8 and 14 hours for your pool to empty. The same goes for filling it.
The main factors are the size of your pool, how many hoses you use, and what kind of water pressure you have. The average outdoor spigot on a home will produce roughly 4 to 12 gallons per minute.
What is the fastest way to drain a pool with a hose?
Submerged one end of the hose inside of the pool, close to the center. Lay the other end of the hose lower than pool water, and leave it in the location where you want to release all the water. The water flow should then reverse, and the pool will begin to drain.
How do you siphon water with a hose uphill?
Fill one container with water and place it on the higher surface. Place the empty container on the lower surface. Put one end of it in the full water container. Fill the hose with water either by completely submerging it or by sucking water through it.
A garden hose is, without a doubt, the cheapest choice for pool owners. It is a bit slow and does not drain the pool up to the last drop. On the other hand, if you think about fixing the existing pool chemicals, this is a worthwhile decision.
Many a time, you might call to siphon out excess water from your pool. With a hose, it is simple, practical, and no additional expense is required.
The situation will dictate how many times you need to repeat it. If circumstances demand total drainage of the pool, you may consider using a pump after that.
Have you ever used a chemical kit for an inflatable pool for kids? Or do you regularly provide it with fresh water? I hope this method of drain pool works for you! By following the actions, your swimming pool will be ready for a great summer season swim.